Flex Watches

Head: Measure around your head about an inch and a half above your ears. Convert this measurement into your appropriate hat size using the above chart.

Neck: Wrap the tape measure around the lower part of your neck. It should be about an inch below your Adam's Apple. Keep it loose enough to fit a finger between the tape and your neck.

Neck: Wrap the tape measure around the lower part of your neck. It should be about an inch below your voice box (larynx). Keep it loose enough to fit a finger between the tape and your neck.

Sleeve: Measure from the middle of the back of your neck to your wrist by putting the tape measure over your shoulder, over your elbow and to your wrist.

Sleeve: Measure from the middle of the back of your neck to the end of where you want the short sleeve to end.

Shoulder to floor/fall: This is the length from your shoulder to where you want the clothing to fall. You should stand upright and your feet should keep together. You should be standing in the correct high heel (shoe) that you wish to wear. Measure from the point which is on your front shoulder close to your neck. It needs to be measured over your bust. If your clothing will be full, be sure to measure out at an angle to allow for the fullness.

Length: Stand up and measure straight along the back from the base of your neck, down to wherever you want the clothing to end.

Height: Measure from the top fo your head all the way down to the flor.

Chest: Wrap tape measure under armpits and around the fullest part of chest (usually right above nipples). Make sure the tape is flat across the back. The tape measure should be snug. Not so tight that it constricts breathing, but not so loose that the tape measure slides down.

Bust: Wrap tape measure under armpits, across shoulder blades at back, making sure the tape is flat across the back and around fullest part of bust at the front. Relax arms at sides while keeping tape parallel with floor. The tape measure should be snug. Not so tight that it constricts breathing, but not so loose that the tape measure slides down.

Waist: Measure around where you normally wear your pants, keeping the tape measure a bit loose or putting one finger between your body and the tape measure.

Length: Measure from the center of the clothing from the waist line down to wherever you want the clothing to end.

Hip: Place the tape horizontally approximately 7 inches below the waist. The Hip/Seat measurement is the largest measurement around the widest part of your hips.

Inseam: Measure from your crotch to back of the ankle bone or where you want your clothing to end.

Thigh: Stand with heels apart and measure around fullest part of thigh (approximately 1 inch below crotch), keeping tape parallel with the floor.

Length: Placing the tape measure flat on the ground measure alongside the inside of your foot from your heel to your longest toe.
Note: If your foot measurement is halfway between sizes, select the larger size.
Note: You may find one foot is longer than the other, this is quite normal, please use the larger size when making your shoe size selection.

Width: Placing the tape measure flat on the ground measure the widest part of your foot.

Hand: Measure loosely around the palm of your hand excluding the thumb.

Diameter: Using a string or piece of paper measure around the base of your finger. Mark the point where the two ends meet. Measure the string or paper against a ruler/tape measure. Find your measurement on the chart above to determine your ring size.
Note: Generally 1/16 of an inch or 1 cm increases the ring size by half a size

Wrist Girth: Measure around the fullest area of your wrist making sure to include the wrist bones.